顺利通过CCNA 200-301考试：CCNA 200-301学习资料，思科认证网络助理资格认证。

You have been tasked with designing a data center interconnect to provide business continuity You want to encrypt the traffic over the DCI using IEEE 802 1AE MACsec to prevent the deployment of any firewall or IPS. Which two interconnect technologies support MACsec? (Choose two.)

Retef to the exhibit. An engineer is designing a multiarea OSPF network for a client who also has a large EIGRP domain EIGRP routes are getting redistributed into OSPF ,OSPF area 20 has routers with limited memory and CPU resources The engineer wants to block routes from EIGRP 111 from propagating into area 20 and allow EIGRP 222 routes to How in Which OSPF area type fulfills this design requirement?

As network designer, which option is your main concern with regards to virtualizing multiple network zones into a single hardware device?

Company XYZ needs advice in redesigning their legacy Layer 2 infrastructure. Which technology should be included in the design to minimize or avoid convergence delays due to STP or FHRP and provide a loop-free topology?

An enterprise wants to provide low-cost delivery of network systems that can be scaled on business demand, followed by an initiative to reduce capital expenses for new IT equipment. Which technology meets these goals'?

An enterprise campus is adopting a network virtualization design solution with these requirements It must include the ability to virtualize the data plane and control plane by using VLANs and VRFs It must maintain end-to-end logical path transport separation across the network resources available grouped at the access edge Which two primary models can this network virtualization design be categorized? (Choose two)

According to the CIA triad principles for network security design, which principle should be priority for a Zero Trust network?

Sometimes SDN leverages various overlay networking technologies to create layer(s) of network abstraction. What describes an overlay network?

An enterprise solution team is performing an analysis of multilayer architecture and multicontroller SDN solutions for multisite deployments. The analysis focuses on the ability to run tasks on any controller via a standardized interface. Which requirement addresses this ability on a multicontroller platform?

As a network designer you need to support an enterprise with hundreds of remote sites connected over a single WAN network that carries different types of traffic, including VoIP, video, and data applications which of following design considerations will not impact design decision?

Which two advantages of using DWDM over traditional optical networks are true? (Choose two.)

Your network operations team is deploying Access Control Lists (ACLs) across your Internet gateways They wish to place an ACL inbound on the Internet gateway interface facing the core network (the "trusted" interface). Which IP address would the ACL need for traffic sourced from the inside interface, to match the source address of the traffic?

Company XYZ wants to secure the data plane of their network. Which two technologies can be included in the security design? (Choose two)

Company XYZ BGP topology is as shown in the diagram. The interface on the LA router connected toward the 10.1.5.0/24 network is faulty and is going up and down, which affects the entire routing domain. Which routing technique can be used in the routing policy design so that the rest of the network is not affected by the flapping issue?

Company XYZ has a hub-and-spoke topology over an SP-managed infrastructure. To measure traffic performance metrics, they implemented IP SLA senders on all spoke CE routers and an IP SLA responder on the hub CE router. What must they monitor to have visibility on the potential performance impact due to the constantly increasing number of spoke sites?

A network engineering team is in the process of designing a lab network for a customer demonstration. The design engineer wants to show that the resiliency of the MPLS traffic Engineering Fast Reroute solution has the same failover/failback times as a traditional SONET/SDH network (around 50MSEC). In order to address both link failure and node failure within the lab typology network, which type of the MPLS TE tunnels must be considered for this demonstration?

Which two factors provide multifactor authentication for secure access to applications and data, no matter where the users are or which devices they are on? (Choose two.)

Refer to the exhibit A service provider has a requirement to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP- SW2 Which two ways to design this solution are true? (Choose two)

Which three tools are used for ongoing monitoring and maintenance of a voice and video environment? (Choose three.)

Which design consideration is valid when you contrast fabricPath and trill?

Which mechanism enables small, unmanaged switches to plug into ports of access switches without risking switch loops?

Which two statements describe network automation and network orchestration? (Choose two.)

Company ABC wants to minimize the risk of users plugging unauthorized switches and hubs into the network Which two features can be used on the LAN access ports to support this design requirement? (Choose two.)